Fit for 2022-2025 Nissan Frontier 9007 HB5 LED Headlight Bulbs H8 H11 Fog Lights

Headlights were a big improvement over stock lights. Just an FYI the fog lights don’t fit. I’m guessing you have to remove the whole housing. There’s not enough room for them. The stock fog lights are at a 90 degree angle. The lights that are sent in the kit are straight like the headlights. In the review section for these lights there’s nothing mentioned in the first set of reviews about them not fitting. If you go to the later sections it’s mentioned a lot about them not fitting. So far customer support has not responded back. Hopefully I’m not stuck with fog lights I can’t use.

Phenomenal lights. Super easy install, don't overthink it. I installed these headlights on a 2025 Frontier SV. Literally plug and play, pay attention to how you remove original halogens, and the grooves on the housing itself, as well as the new headlight ring. Only took me about 10-15 minutes cause I just bought this truck and never messed with Nissan headlight housings. Once I got one side, the other took less than 2 minutes. Only other recommendation is to zip tie the excess wiring hanging about, you might hear some clanging around cause they hang freely. That can be mitigated though. 10/10 product. Still have yet to see the difference at night. I turned my garage lights off, and turned the headlights on, and BANG! TOTAL difference. Bright white, clear crisp light.

I purchased the Headlights (9007) for my Frontier and couldn't be happier with them. They're a Tremendous improvement over the factory halogen bulbs. High & low beam function as expected, and as long as you seat them appropriately in the headlamp housing (with emitters at 90 and 270 degrees), they will maintain the OEM light dispersion, but brighter and whiter. Trust me, you will not regret this purchase!

I've always used Lasfit with zero issues. These are the first 9007 I have used though. I must say, I'm not impressed with fit and tightness of the housing after putting the locking ring on. The brightness is great, as always, but the bulb seems to have a bounce to it when driving. Everything is in place. It simply does not seat down to make it fully tight. This causes the right bulb to face inward a bit as well. Ruining the beam pattern on the passenger side. Mainly, its pointing left and not illuminating the ditch. I may play with some o rings to see if I can solve the issue, but I shouldn't need non supplied parts to make this work. Any advice here Lasfit?

Edit: Updated to four fingers. Lasfit was swift in sending a replacement set of bulbs. CS has been nothing short of amazing. I will say that the bulbs still fit a bit looser than what I would believe to be tight, but they are definitely closer to where they should be. They do not have shake to them when hitting harsh bumps. Shared some possible fixes to this with CS and they seemed to take the constructive criticism well. They said they would forward information to the design team. I still have my faith in Lasfit and will continue to purchase and preach their products. Thank you Lasfit!

I ordered a set of fog lights on January 15 2025 and the one on passenger side not working new. Ordered a new set will put in when get like them a lot give good light when using them